RS485 MODBUS Dissolved Oxygen SensorRS485 MODBUS Dissolved Oxygen Sensor RS485 Modbus Dissolved Oxygen Sensor is based on the fluorescence quenching method, which can quickly measure dissolved oxygen in water, it has a built in temperature sensor and salinity compensation to make the measurement more accurate. It has a long service life due to its unmatched chemical and abrasion resistance. And the sensor will not be affected by flow rate and chemical substances, resists interference

Data protocol: UART & I2C

Run up to 6+ sensors in the same environment

3V or 5V power supply

Data protocol: Analog ~0 − ~3

then the click needs the power supply unit connected to the VIN screw terminal

IP65 (shading measures are required for outdoor installation

Power-gain: 2dB

one Ethernet Port is connected to the Gigabit Ethernet PHY of the CM4 module which is based on Broadcom BCM54210PE

The sensor is designed and calibrated to provide reliable range information to large targets

0V Antenna connector 6x IPEX-4 connector

Encrypt firmware of clients to prevent cracking

The PhidgetCircularTouch detects changes in the capacitance between the on-board electrodes and the object making contact