Bezels, Angle Gauge Bezels-4 5/8Designed for use with Livorsi, Gaffrig Monster Tachometers and Monster GPS Speedos and Autometer Monster Tachometers and Speedometers where the size of the instrument housing and size of the dash mounting hole are approximately 4 5 8". Outside diameter of the bezel is 5 5 8".

seamless marine grade vinyl construction with molded ribs

The drain end cap is 3/4" O

these ball valves feature a stainless steel ball

The cooler incorporates cast end caps

They are cast from high quality aluminum and machine finished across the face to insure a consistent surface for polishing

No-slack indicators have an inherent accuracy of a few thousandths of an inch

(1) Bolt Kit

Autometer used their years of competition gauge manufacturing to evaluate not only what was lacking in current GPS Speedometer technology but to also evaluate the signal and receiver so that they could reduce the cost making this technology more affordable to all boaters

the outer edge features an oversized contoured knurl making for easy removal

PowerFlow manifolds are water-jacketed

Each kit comes with the necessary sealing o-rings

They give you the ultimate look for your engine compartment