QUILT 10 HEXAGON CENTER DIE - Gina Marie Designs4x4 sized Tips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using this trick! Plate

65 tall/wide

It frames beautifully on an A2 card

castle - 2

4x6 inch sheet stamp set

Now you can drop stitch marks on your paper without cutting anything out

The inner lattice panel is VERY tiny and petite

PLEASE NOTE

Beautiful full panel die

There are 99 self adhesive dots per pack

BOTH STAMP AND DIES ARE INCLUDED IN THIS

Largest layer measures 4

Largest layer is approx 4x4