3/4"-20 x 11/16"-36 Universal Joint, WoodwardHyper Racing # 16 620 Fits the Hyper Racing Power Steering Unit to the collapsible Steering Shaft. Woodward Universal Joints are made to exacting standards from hardened chrome vanadium tool steel in two sizes. They feature ball bearing with grease seal design, stainless truss head screws, and two set screws at each end. We recommend removing the stock set screws and replacing with a 28 x " set screw with a jam nut, this will allow the set screw to

the right rear is typically just a female and male rod end threaded together making a 3-1/4" center to center shackle and the left rear is a 2" shackle rod making a 4" center to center shackle with the rod ends screwed in

Include grease fitting

Hyper Racing's exclusive Jacob's Jacker® is a system that allows the remote adjustment of the Jacob Ladder's (W-link) roll center while you are in the cockpit on the racetrack

Fits 1-½" 23 tooth splined rear axle

Hyper Racing # 02-235

Fits Hyper X4 and other manufacturer's Chassis

quicker ratio

Hyper Racing # 04-608

19" from and of axle to end of full spline on left

Note: photo shows cap assembly

Hyper Racing # 141-530B

Hyper Racing # 041-101