Team Associated - Factory Team Pinion Gear, 17 Tooth-MOD 1, 5mm Shaft, AluminumMade from hard anodized 7075 aluminum and offer a lighter rotating mass over a steel gear. Fewer teeth = quicker acceleration. More teeth = more top end speed. Use only with plastic spur gears. Fits 1: 8 vehicles: RC8B3e RC8B3. 1e RC8B3. 2e RC8T3e RC8T3. 1e RC8T3. 2e

and 10 gauge sizes and available with either red or black insulation

7075 Futaba/25 spline

After embarking on the construction of the "Autobahn" motorway in 1933

Separate black ABS resin/plastic parts depict side mirrors

GOM Interior Cockpit (Clear)

and USAF P-80s were unable to land in areas where there were frequently no proper runways

This will allow you to use 17mm Tires and Wheels on your Traxxas Jato

The Germans tested the prototype in the Kumahsdorf Proving Ground and accepted it for mass production

Hard anodized 7075 aluminum alloy 38T idler gear for the TLR 22 4

while on the water

A standard power plug fits directly into your transmitter or receiver/switch harness while a XH balance connector allows for simple balance charging

the high durability and impact resistance allows drivers to unleash the full potential of the chassis