Baldur's Gate 3 Mysterious ArtifactBased on the Mysterious Artefact from Baldur's Gate 3! This item is designed to be printed in resin, with LED's placed inside to make the base and spikes glow. The letters on each panel are carved deep enough so that they will also glow from beneath if the bottom of the panel is left unpainted. The base is split into two pieces, with magnet holes on each sized for round 5mm x 1mm magnets.

through the cylinder

- Magnet holes

You can use lightsaber electronics to insert into this 3d printed project to make it a functional lightsaber

The "coral" textures are not only by design choice but they would also act as a grip texture which would be very useful in combat

In Collaboration With: @ EMILYTHEENGINEER

This is a fan art representation inspired by the CQS Bulldog

A visor can be 3d printed using tinted clear resin or use the visor buck included for vacuum forming

Why is it special

but that's up to your own discretion

Remember to lay a low profile and don't get into any-

Thank you for your support and good luck out there

so please check the size of your hand to make sure your fingers fit in the trigger holes