Rubber, vulcanized or thermoplastic. Determination of adhesion to metal. Two-plate method1 Scope This document specifies a method for determining the adhesion strength of rubber to metal bonds where the rubber part is assembled between two parallel metal plates, using the adhesive system under investigation. The method is applicable primarily to test pieces, prepared in the laboratory under standard conditions, such as can be used to provide data for the development of rubber compounds and control of methods of manufacture.

This Technical Report is applicable only to a laterally homogeneous bulk or single-layered material where the ion-sputtering rate is determined from the sputtered depth

Manufacturers and designers of rail track

On-board rechargeable energy storage system (RESS)

They are mainly intended for use in slaughterhouses and rooms

Since elevated gaschallenge concentrations (relative to general ventilation applications) are used

or to read data from

At very low ratios of pressure differential to absolute inlet pressure (∆p/p1)

and optically active components

no compression power tools driven by internal combustion engines are known

In this part of PD ISO/IEC TR 24714

— national contact point for the latest information

so that the filters may be used to their best advantage