C123E-200 Locking AssemblySingle taper, self centering design without mounting flange for use in through bored components. Mounted component moves axially during installation. View Catalog PageInstallation & Removal Instructions

Ideal for washdown environments & is USDA approved

Provides torque transmission & alignment

self-centering design with mounting flange for use in through-bored components

Adapters eliminate the need for complete shaft replacement

Design fully engages the thread for secure locking

Entire unit is UHMW-PE

Provides greater axial holding power than set screw or one-piece clamping collars

Self-lubricating bearings resist corrosions

USDA/FDA approved

These specially designed collars fit over rail assemblies on precision shafting

Extra thick non-conductive rubber liner corrects misalignment up to 2° while reducing noise & vibration

Keyless Rigid Coupling with high torque and overhung load capacity