PG1302 LoRaWAN ConcentratorPG1302 LoRaWAN Concentrator The PG1302 is a multi channel high performance transmitter receiver designed to simultaneously receive several LoRa packets using random spreading factors on random channels. Its goal is to enable the robust connection between a central wireless data concentrator and a massive amount of wireless end points spread over a very wide range of distances. The PG1302 is designed to use with Raspberry Pi to build smart metering

High sensitivity: -148 dBm

On-board modules AT30TSE758A

Factory Calibrated

768 kHz signal with an amplitude of about 0

This EC & TDS Sensor is IP65 rated

just simply install a LoRaWAN gateway - it's as simple as setting up a Wi-Fi router

allowing them to determine their proximity to the beacon， building a location-based solution for indoor positioning

1x RAK314 CM4 baseboard

The SMD jumper labeled as CS SEL is used to select the CS pin voltage level

If you connect this up the way it is marked you will not damage the board

M-DUINO PLC Arduino Ethernet 38R+ I/Os Relay/Analog/Digital PLUS

and -40 to +125 degrees of Celsius