Shrink chuck 3° HSK 63 - 06 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

- Warranty card

Perforated plate for mounting accessories

In the tailstock of the lathe so that no friction between the workpiece and the tip occurs

3 µm radial run-out with a 2 µm clamping nut

Adapters ISO / PSK with axial clamping

The base is designed with a thermal heat isolation hand grip

Minimum internal diameter measurement capability of:

Dial Graduation: 1°

T-nuts 18 mmTest certificate

Hydraulic or manual clamping

For clamping nuts ER-system

102 x 35 x 15