Shell mill holder BT 40 - 16 - 40Application: For mounting milling cutters with transversal groove. Note: d = 40 d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079. SK 30 without coolant exit bores on the end faceDelivery: With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912. All holders are made of forged steel

5-30mm and 25-50mm range are supplied with setting rings

Calibration certificat

Starting position is kept when turned on

All holders are made of forged steel

For mounting straight-shank tools in 3µm-collets

Bearing edge ground

102 x 45 x 15

For clamping tools with Morse taper shank and thread according to DIN 228-1 form A

PSK = PSK 63

- Higher repeat-accuracy

chip breaking

E3= 5 pieces