Rubber, vulcanized. Determination of adhesion to wire cord1 Scope This document specifies two methods for determining the adhesion strength of vulcanized rubber to wire cord which is embedded in the rubber. The two methods do not necessarily give the same results. They are applicable primarily to test pieces prepared in the laboratory under standard conditions and used for the development and control of materials and processes utilized in the manufacture of products reinforced with wire cord. NOTE The

This process of gassing of the insulating liquid can be harmful to the components as it is in direct contact to them

Broadband and narrowband radiated electromagnetic disturbances

BS EN 1894 applies to all-ceramic matrix composites with continuous fibre reinforcement

It is not applicable to the following items:

'1 Set + 4 Minutes Test'

BS EN 61158-5-14 provides migration paths from previously-existing industrial communications protocols

This European Standard specifies the minimum requirements for swage terminals and the securing of such terminals by a swaging process to carbon steel rope conforming to EN 12385‑4 and EN 12385‑5

Note: BS 7350 does not cover methods of installation

the environmental impact is reduced when the combustion process is optimised (e

BS 4505-2 also specifies the parity sense to be used with the 7-bit coded character set

This International Standard is not applicable for the determination of organic content of adhesives

This European Standard specifies the requirements for blown loose-fill mineral wool products installed in lofts