Shrink chuck 4,5° HSK 32 - 06 - 70Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

For adaption from ISO40 to PSC (ISO 7388-1 to ISO 26623-1)

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance3

For setting the tool in the HKS collet chucks

The caliper will be ready for measurements as soon as it is switched on with the LCD screen displaying the actual slider position

Instructions for use

Torque range : 20-110 Nm

such as precision boring bars

DIN 1835 form A+B+E and DIN 6535 form HB+HE (larger than Ø 20 mm only with reduction sleeve)

PSK = PSK 63

Adapters HSK / PSK with axial clamping

Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap

Nubs on the top of the inserts