Rubber- or plastics-coated fabrics. Determination of abrasion resistance - Martindale abrader1 Scope This part of ISO 5470 details two separate methods for determining the resistance of a material to wet and dry abrasion. It is applicable to the coated surface or surfaces of coated fabrics. If the abrasion behaviour of the uncoated surface of a coated fabric is to be determined, use the methods for uncoated textiles described in the various parts of ISO 12947.

Fixed surface mount inductors are very common in electronics and telecommunication equipment

and tested substrate

The lower limit of the validation range was determined under operational conditions of a test plant

This helps in maintaining data properly and allows recall for product correction or patient follow-up in the event of unforeseen device malfunction

BS EN IEC 62343‑1on dynamic modules is useful for:

a) Annexes common to several parts of the ISO 3506 series have been withdrawn from this document and are now included in a new document (ISO 3506-6)

for example chemical

BS EN IEC 62878‑1 best practice guidelines can help you in applying safety requirements while performing the test method

This International Standard specifies the dimensions and designation of countersinks for countersunk head screws with a head configuration in accordance with ISO 7721

BS EN 62481‑3 provides guidelines for general and device-specific networking capabilities that are independent of the Link Protection System used

This document does not apply when the wool content exceeds 25 %

With obedience and compliance to BS 5381-8