Thermal insulating products. Factory made products of expanded polystyrene (EPS). Voluntary certification of the raw material1 Scope It is essential that EPS products with a reaction to fire performance better than Euroclass F be manufactured from raw materials with a chemical composition, which is under the control of the raw material producer. This Technical Report specifies the conditions allowing reduction of the FPC frequency for testing the reaction to fire of specimens made from flame retardant EPS raw material. The preconditions are that products are manufactured

This standard does not apply to coatings applied by other processes

It is intended that this part of BS EN ISO 14122 is used with BS EN ISO 14122-1 to give the requirements for walking platforms and walkways

and application of markings

This part of BS EN ISO 11137 provides guidance on the application of dose measurements (dosimetry) during all stages of the sterilization process

The indirect method covers a frequency range that is determined by the test set-up and the isolator under test

test methods and procedure

It applies to fully penetrated welds

Heating units intended exclusively for industrial purposes

It addresses their anthropometric and biomechanical properties

Why should you use BS EN 13887 - Structural adhesives

BS 9295 gives further information on the structural design of buried pipelines under various conditions of loading using the established United Kingdom (UK) method

8 Load capacity and stability