Process management for avionics. Atmospheric radiation effects - System design optimization to accommodate the single event effects (SEE) of atmospheric radiation

5 Principle

• Selection of appropriate tests that reflect realistic end-use conditions

BS EN 14467:2004 (ISO 24803:2007) applies to service providers – usually dive centres or clubs – that offer training

is applicable as the basis for the design

BS 7363 describes the BOP test for welds

It applies to the same scope of application as BS EN 1090-2 with the following exceptions:

This Technical Report is not intended to be comprehensive or complete

The hollow insulators are intended for use in electrical equipment

NOTE Annex R (informative) lists the existing published ISO and EN hose test methods standards that are specified within fire-fighting hose standards

Manufacturer of specified floorings

BS EN 13060 assists you with general technical requirements

BS EN 60745-2-22 is a part of the EN 60745 multi-series that discusses the safety of hand-held motor-operated electric tools