Cranes. Measurement of the mass of a crane and its components1 Scope This International Standard sets forth basic procedures for measuring the mass of a cranes as a whole and or of its components. This International Standard was prepared in addition to ISO 4310 and covers the types of cranes as defined in ISO 4306 1.

for direct application

Approximate rate of spread (Table B

BS 7036-2:1996

Other titles in the PAS 1188 series:

the manufacturer needs to verify the effectiveness of the information for safety before it can be accepted

the Jones matrix eigenanalysis (JME) and the Poincaré sphere analysis (PSA)

It can be used in a risk assessment of electrostatic hazards or for the preparation of product family or dedicated product standards for electrical or non-electrical machines or equipment

Why should you use ISO 6150 - Pneumatic fluid power

complying with BS EN 15564 helps you to demonstrate the performance and quality of your products

7 Physical (PHY) layer specification

DD IEC/PAS 62545 focuses on manufacturers or producers as they perform a key role in this chain

for which reference should be made to BS 8300